Conceptual Design and Structure Analysis of Giromill Vertical Axis Wind Turbine under Low Wind Speed

Authors

  • Mohamed Saiful Firdaus Hussin Faculty of Mechanical & Manufacturing Engineering Technology, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • Mohd Fariduddin Mukhtar Advanced Manufacturing Centre, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • Mohd Zaidi Mohd Tumari Faculty of Electrical & Electronics Engineering Technology, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • Nursabillilah Mohd Ali Faculty of Electrical & Electronics Engineering Technology, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • Amir Abdullah Muhammad Damanhuri Centre for Advanced Research on Energy, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • Noor Saffreena Hamdan Centre for Advanced Research on Energy, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • Khairul Azri Azlan Advanced Manufacturing Centre, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
  • Khairul Amri Tofrowaih Centre for Advanced Research on Energy, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia

Keywords:

Giromill Blade, Low Wind Speed, Pugh Method, Topology Optimization

Abstract

Unstable wind speed in Malaysia has been a problem for the wind turbine. Vertical axis wind turbine (VAWT) that is placed on the ground causes unnecessary stress and hinder it to perform at maximum performance. Thus, the purpose of this study was to analyze the behavior of VAWT at different wind speed. The conceptual design was generated by using the pugh method. Then the structure of the blade was analyzed in terms of displacement and von Mises stress, followed by topology optimization. Results show that peak stress for both forces applied and pressure applied was located at the center where maximum displacement is about 5.43x10-6m while the maximum value of von Mises stress is about 0.9763Mpa at the edge of the blade and 0.6641MPa when pressure is distributed uniformly. Based on topology optimization, the blade area can still be reduced at the top and bottom part.

 

Downloads

Download data is not yet available.

Downloads

Published

2024-03-28

How to Cite

Mohamed Saiful Firdaus Hussin, Mohd Fariduddin Mukhtar, Mohd Zaidi Mohd Tumari, Nursabillilah Mohd Ali, Amir Abdullah Muhammad Damanhuri, Noor Saffreena Hamdan, Khairul Azri Azlan, & Khairul Amri Tofrowaih. (2024). Conceptual Design and Structure Analysis of Giromill Vertical Axis Wind Turbine under Low Wind Speed. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 75(2), 11–19. Retrieved from https://semarakilmu.com.my/journals/index.php/fluid_mechanics_thermal_sciences/article/view/6755

Issue

Section

Articles

Most read articles by the same author(s)