Laboratory Investigation of Nozzle Type, Size and Pressure Effects on Spray Distribution

Authors

  • Nasir Salim Hassen Department of Thermo fluid, Faculty of Mechanical Engineering Universiti TechnologiMalaysia, 81310,Skudai,Johor, Malaysia
  • Nor Azwadi Che Sidik Malaysia –Japan International Institute of Technology (MJIIT), Universiti TeknologiMalaysia Kuala Lumpur, Jalan Sultan Yahya Petra (JalanSemarak), 54100 Kuala Lumpur, Malaysia

Keywords:

Spray distribution, pattrenator, nozzle type, banding application

Abstract

The current study attempts to experimentally determine the effects of nozzle type, size andpressure on spray parameters. A total of 8 even flat fan nozzles were tested at pressures of 2 and 3bar. Spraying pattern analyzing method (pattrenator) was used to measure spray width and distribution.Liquid volume under the nozzle from pattrenator was quantified by weight method using precisionelectrical balance. The results indicated that DG flat fan nozzle behaviour was to some extent similar to that TP flat fan nozzle but additional variables like increase of spray width. Results also showed that small variations in nozzle pressure can cause significantdifferencein spray width and spray distribution. The current work presents liquid volume data under the nozzle centre increased with increasing nozzle size.

Downloads

Download data is not yet available.

Downloads

Published

2024-03-28

How to Cite

Nasir Salim Hassen, & Nor Azwadi Che Sidik. (2024). Laboratory Investigation of Nozzle Type, Size and Pressure Effects on Spray Distribution. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 61(1), 140–146. Retrieved from https://semarakilmu.com.my/journals/index.php/fluid_mechanics_thermal_sciences/article/view/3501

Issue

Section

Articles

Most read articles by the same author(s)

1 2 3 > >>