Numerical Investigation of the Effect of Ethylene Glycol with SnFe2O3 Hybrid Nanofluid on Heat Transfer in Flat, Face Step, and Radial Corrugated Microchannels
DOI:
https://doi.org/10.37934/cfdl.15.10.7192Keywords:
Nanofluid, hybrid nanofluid, heat transfer, microchannel, heat exchangersAbstract
Nanofluid technology is one of the latest technics aims to enhance the heat exchangers working systems. The nanofluid is used because it has better thermal performance properties than common fluids like water. Tin Oxide (SnO2) and Ferric Oxide (Fe2O3) has used due to their availability and low cost for manufacturing. Flat, face step and radial corrugated microchannels have been studied at the Reynolds number range (4000-7000 Re). In this study, a hybrid nanofluid combined Ferric Oxide and Tin Oxide SnFe2O3 at (0, 5, 15%) of Tin Oxide concentration. The volume concentration of the nanoparticles was from (1-5)% suspended in ethylene glycol as base fluid due to its high thermal performance compared with water. The performance evaluation criteria (PEC) are studied and the results were validated with experimental and numerical results from previous studies. Performance evaluation criteria (PEC) studied the heat transfer in all study steps and found that the 15Sn85Fe2O3 hybrid nanofluid in ethylene glycol at 5% volume concentration in radial corrugated microchannel increased 104% compared with base fluid ethylene glycol in the flat microchannel. The performance evaluation criteria value has increased by 82% from flat microchannel to radial microchannel at 5% of volume concentration of 15Sn85Fe2O3 hybrid nanofluid
Downloads
References
Akbari, Omid Ali, Davood Toghraie, and Arash Karimipour. "Impact of ribs on flow parameters and laminar heat transfer of water-aluminum oxide nanofluid with different nanoparticle volume fractions in a three-dimensional rectangular microchannel." Advances in Mechanical Engineering 7, no. 11 (2015): 1687814015618155. https://doi.org/10.1177/1687814015618155
Dogonchi, A. S., Ali J. Chamkha, S. M. Seyyedi, and D. D. Ganji. "Radiative nanofluid flow and heat transfer between parallel disks with penetrable and stretchable walls considering Cattaneo-Christov heat flux model." Heat Transfer-Asian Research 47, no. 5 (2018): 735-753. https://doi.org/10.1002/htj.21339
Thumma, Thirupathi, O. Anwar Bég, and A. Kadir. "Numerical study of heat source/sink effects on dissipative magnetic nanofluid flow from a non-linear inclined stretching/shrinking sheet." Journal of Molecular Liquids 232 (2017): 159-173. https://doi.org/10.1016/j.molliq.2017.02.032
Eshgarf, Hamed, Afshin Ahmadi Nadooshan, and Afrasiab Raisi. "A review of multi-phase and single-phase models in the numerical simulation of nanofluid flow in heat exchangers." Engineering Analysis with Boundary Elements 146 (2023): 910-927. https://doi.org/10.1016/j.enganabound.2022.10.013
Alklaibi, A. M., Kotturu V. V. Chandra Mouli, and L. Syam Sundar. "Experimental investigation of heat transfer and effectiveness of employing water and ethylene glycol mixture based Fe3O4 nanofluid in a shell and helical coil heat exchanger." Thermal Science and Engineering Progress 40 (2023): 101739. https://doi.org/10.1016/j.tsep.2023.101739
Chiam, H. W., W. H. Azmi, N. M. Adam, and M. K. A. M. Ariffin. "Numerical study of nanofluid heat transfer for different tube geometries-A comprehensive review on performance." International Communications in Heat and Mass Transfer 86 (2017): 60-70. https://doi.org/10.1016/j.icheatmasstransfer.2017.05.019
Shah, Zahir, Poom Kumam, and Wejdan Deebani. "Radiative MHD Casson Nanofluid Flow with Activation energy and chemical reaction over past nonlinearly stretching surface through Entropy generation." Scientific Reports 10, no. 1 (2020): 4402. https://doi.org/10.1038/s41598-020-61125-9
Choi, S. US, and Jeffrey A. Eastman. Enhancing thermal conductivity of fluids with nanoparticles. No. ANL/MSD/CP-84938; CONF-951135-29. Argonne National Lab.(ANL), Argonne, IL (United States), 1995.
Wang, Xinwei, Xianfan Xu, and Stephen US Choi. "Thermal conductivity of nanoparticle-fluid mixture." Journal of Thermophysics and Heat Transfer 13, no. 4 (1999): 474-480. https://doi.org/10.2514/2.6486
Afshari, Faraz, Azim Doğuş Tuncer, Adnan Sözen, Halil Ibrahim Variyenli, Ataollah Khanlari, and Emine Yağız Gürbüz. "A comprehensive survey on utilization of hybrid nanofluid in plate heat exchanger with various number of plates." International Journal of Numerical Methods for Heat & Fluid Flow 32, no. 1 (2022): 241-264. https://doi.org/10.1108/HFF-11-2020-0743
Hassan, Qais Hussein, Shaalan Ghanam Afluq, and Mohamed Abed Al Abas Siba. "Numerical investigation of heat transfer in car radiation system using improved coolant." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 83, no. 1 (2021): 61-69. https://doi.org/10.37934/arfmts.83.1.6169
Nashee, Sarah Rabee, and Haiyder Minin Hmood. "Numerical Study of Heat Transfer and Fluid Flow over Circular Cylinders in 2D Cross Flow." Journal of Advanced Research in Applied Sciences and Engineering Technology 30, no. 2 (2023): 216-224. https://doi.org/10.37934/araset.30.2.216224
Muhammad, Noor, and Sohail Nadeem. "Ferrite nanoparticles Ni-ZnFe2O4, Mn-ZnFe2O4 and Fe2O4 in the flow of ferromagnetic nanofluid." The European Physical Journal Plus 132 (2017): 1-12. https://doi.org/10.1140/epjp/i2017-11650-2
Kleinstreuer, Clement, and Yu Feng. "Experimental and theoretical studies of nanofluid thermal conductivity enhancement: a review." Nanoscale Research Letters 6 (2011): 1-13. https://doi.org/10.1186/1556-276X-6-229
Das, Sarit Kumar, Stephen U. S. Choi, and Hrishikesh E. Patel. "Heat transfer in nanofluids-a review." Heat Transfer Engineering 27, no. 10 (2006): 3-19. https://doi.org/10.1080/01457630600904593
Yu, Wenhua, David M. France, Jules L. Routbort, and Stephen U. S. Choi. "Review and comparison of nanofluid thermal conductivity and heat transfer enhancements." Heat Transfer Engineering 29, no. 5 (2008): 432-460. https://doi.org/10.1080/01457630701850851
Salman, S., A. R. Abu Talib, S. Saadon, and M. T. Hameed Sultan. "Hybrid nanofluid flow and heat transfer over backward and forward steps: A review." Powder Technology 363 (2020): 448-472. https://doi.org/10.1016/j.powtec.2019.12.038
Urmi, Wajiha Tasnim, A. S. Shafiqah, Md Mustafizur Rahman, Kumaran Kadirgama, and Md Abdul Maleque. "Preparation methods and challenges of hybrid nanofluids: a review." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 78, no. 2 (2020): 56-66. https://doi.org/10.37934/arfmts.78.2.5666
Ajith, K., I. V. Muthuvijayan Enoch, A. Brusly Solomon, and Archana Sumohan Pillai. "Characterization of magnesium ferrite nanofluids for heat transfer applications." Materials Today: Proceedings 27 (2020): 107-110. https://doi.org/10.1016/j.matpr.2019.09.014
Bazdar, Hamed, Davood Toghraie, Farzad Pourfattah, Omid Ali Akbari, Hoang Minh Nguyen, and Amin Asadi. "Numerical investigation of turbulent flow and heat transfer of nanofluid inside a wavy microchannel with different wavelengths." Journal of Thermal Analysis and Calorimetry 139 (2020): 2365-2380. https://doi.org/10.1007/s10973-019-08637-3
Firlianda, Dinda Anggara, Avita Ayu Permanasari, Poppy Puspitasari, and Sukarni Sukarni. "Heat transfer enhancement using nanofluids (MnFe2O4-ethylene glycol) in mini heat exchanger shell and tube." In AIP Conference Proceedings, vol. 2120, no. 1. AIP Publishing, 2019. https://doi.org/10.1063/1.5115690
Moraveji, Mostafa Keshavarz, and Reza Mohammadi Ardehali. "CFD modeling (comparing single and two-phase approaches) on thermal performance of Al2O3/water nanofluid in mini-channel heat sink." International Communications in Heat and Mass Transfer 44 (2013): 157-164. https://doi.org/10.1016/j.icheatmasstransfer.2013.02.012
Manay, Eyuphan, and Bayram Sahin. "Heat transfer and pressure drop of nanofluids in a microchannel heat sink." Heat Transfer Engineering 38, no. 5 (2017): 510-522. https://doi.org/10.1080/10407782.2016.1195162
Ben-Mansour, R., and M. A. Habib. "Use of nanofluids for improved natural cooling of discretely heated cavities." Advances in Mechanical Engineering 5 (2013): 383267. https://doi.org/10.1155/2013/383267
Xuan, Yimin, and Wilfried Roetzel. "Conceptions for heat transfer correlation of nanofluids." International Journal of Heat and Mass Transfer 43, no. 19 (2000): 3701-3707. https://doi.org/10.1016/S0017-9310(99)00369-5
Pak, Bock Choon, and Young I. Cho. "Hydrodynamic and heat transfer study of dispersed fluids with submicron metallic oxide particles." Experimental Heat Transfer an International Journal 11, no. 2 (1998): 151-170. https://doi.org/10.1080/08916159808946559
Lide, David R., ed. CRC handbook of chemistry and physics. Vol. 85. CRC Press, 2004.
Wen, Dongsheng, and Yulong Ding. "Experimental investigation into convective heat transfer of nanofluids at the entrance region under laminar flow conditions." International Journal of Heat and Mass Transfer 47, no. 24 (2004): 5181-5188. https://doi.org/10.1016/j.ijheatmasstransfer.2004.07.012
Göktepe, Sinan, Kunt Atalık, and Hakan Ertürk. "Comparison of single and two-phase models for nanofluid convection at the entrance of a uniformly heated tube." International Journal of Thermal Sciences 80 (2014): 83-92. https://doi.org/10.1016/j.ijthermalsci.2014.01.014
Abu Talib, Abd Rahim, and Sadeq Salman. "Heat transfer and fluid flow analysis over the microscale backward-facing step using βGa2O3 nanoparticles." Experimental Heat Transfer 36, no. 3 (2023): 358-375. https://doi.org/10.1080/08916152.2022.2039328
Salman, Sadeq, Abd Rahim Abu Talib, Ali Hilo, Sadeq Rashid Nfawa, Mohamed Thariq Hameed Sultan, and Syamimi Saadon. "Numerical study on the turbulent mixed convective heat transfer over 2d microscale backward-facing step." CFD Letters 11, no. 10 (2019): 31-45.
Manca, Oronzio, Sergio Nardini, and Daniele Ricci. "A numerical study of nanofluid forced convection in ribbed channels." Applied Thermal Engineering 37 (2012): 280-292. https://doi.org/10.1016/j.applthermaleng.2011.11.030
Downloads
Published
How to Cite
Issue
Section
