Simulating the Rising Air Bubbles Stream through Heavy Fuel Oil Residue Bubble Column Reactor using COMSOL

Abstract

Several industrial operations rely on the rise of air bubbles through heavy fuel oil residue (HFOr), including oil recovery and wastewater treatment. In order to increase efficiency and decrease expenses, it is necessary to understand the peculiarities of this process. With the help of COMSOL Multiphysics, we numerically simulate the ascent of a single air bubble via HFOr in this article. The dimensions of the container used in the simulations were (100) mm in diameter and (200) mm in height, with an air bubble diameter of 4.5 mm. For an air bubble ascending through an HFOr column, the predicted numerical outcomes are contrasted with nine experimental versions. As the bubble rose higher, the region with the greatest number of vortices was located on its side. The remaining vortex is contained inside the bubble. In addition, since drag decreases the flow, a lighter fluid usually exhibits a region of strong vortex and low pressure. Because of the oscillation effect, the results reveal that the rising velocity initially rises and then gradually falls between 0.6 and 0.65 s. The air bubbles' wavy motion is caused by the high fluid density, which becomes worse as the air velocity gets higher. The values of the drag coefficient rise sharply with decreasing air extrusion speed. It turns out that the height of the fluid has an inverse relationship with the pressure.