The Evaluation of Drag and Lift Force of Groove Cylinder in Wind Tunnel

Authors

  • Wan Mohamad Aiman Wan Yahaya School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia
  • Syahrullail Samion School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia
  • Fazila Mohd Zawawi School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia
  • Mohd Nor Musa School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia
  • Muhammad Naim Aiman Najurudeen School of Mechanical Engineering, Faculty of Engineering, Universiti Teknologi Malaysia, 81310 UTM Skudai, Johor, Malaysia

Keywords:

Drag force, lift force, wind tunnel, aerodynamics, flow visualization

Abstract

Cylindrical structures subjected to flow are widely used in marine and offshore engineering and in structural applications. It has been shown that circular cylinder surface modifications can affect the separation point to move backward on the cylinder surface. Thus, reducing the drag coefficient. Flow past a circular cylinder with smooth, half and full rectangular, grooved surfaces (roughness coefficient k⁄D=0.04) were investigated in a low-speed open ended wind tunnel. The outer diameters (D) of the cylinders were 50mm and the depths (k) of the grooves were 2mm. The Reynold’s number ranged from 1.65x104 to 1.13x105. The drag and lift coefficients of the cylinders were measured using a three-component balance. The wake flow patterns of the cylinders were observed using a smoke visualization technique. The results show that the full grooves and half grooves facing the flow produced a lower drag than a smooth cylinder with a half groove located at the leeside of the flow. The full grooved cylinder showed a drag reduction of 55% at Re=1x105. The presence of the groove on the cylinder’s surface tripped the boundary layer and showed a smaller and narrower wake than a smooth cylinder.

Downloads

Download data is not yet available.

Downloads

Published

2024-03-28

How to Cite

Wan Mohamad Aiman Wan Yahaya, Syahrullail Samion, Fazila Mohd Zawawi, Mohd Nor Musa, & Muhammad Naim Aiman Najurudeen. (2024). The Evaluation of Drag and Lift Force of Groove Cylinder in Wind Tunnel. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 68(2), 41–50. Retrieved from https://semarakilmu.com.my/journals/index.php/fluid_mechanics_thermal_sciences/article/view/5994

Issue

Section

Articles

Most read articles by the same author(s)

1 2 > >>