Effects of Fin Height, Fin Thickness and Reynolds Number on Heat Transfer Enhancement of Flat-Plate Thermal Collector: A Numerical Analysis
DOI:
https://doi.org/10.37934/cfdl.15.4.5363Keywords:
Fins, geometry, CFD, Reynold Numbers, heat transfer, flat-plate, collectorAbstract
A flat-plate thermal collector combined with a PV panel also called a PV/T collector is a device that converts solar irradiation into thermal energy and electrical energy simultaneously. The unused thermal energy of the PV/T collector is absorbed by the flat-plate thermal collector. This may then contribute directly to an enhancement of the electrical efficiency of the PV/T collector. In the present study, the effect of geometry and Reynolds Number on the thermal performance of flat-plate thermal collectors is numerically investigated. Thereafter, CFD simulation is then implemented to characterize the thermal performance in terms of absorber temperature and convection heat transfer coefficient. To disturb the fluid flow pattern in this work the 45o inclined fins are attached underneath the surface of the collector model and they act as an absorber. Monthly average weather data of inlet fluid temperature and ambient temperature as well as solar irradiation level implemented in this study were obtained from the Meteorological, Climatological and Geophysical Agency of Bandarlampung regency. Several different cases have been considered by varying the fin height from 20 to 80 mm, fin thickness from 1 to 4 mm, and Reynolds number from 1500 to 6000. The results show that increasing the fin geometry (the fin thickness and fin height) and Reynolds Number reduce the flat-plate surface temperature due to the more conductive and convective heat transfer process. However, in terms of the convective heat transfer coefficient parameter, the Reynolds Number implemented has a dominant effect compared to the fin geometry. Moreover, by increasing Reynolds Number by four times, there is a decrease in the mean surface temperature by 26% and an increase in the mean convective heat transfer coefficient of 146% compared to the initial conditions
Downloads
References
Ya, Cengel, A. Ghajar, and H. Ma. "Heat and Mass Transfer Fundamentals & Applications." McGraw-Hill (2015).
Azarkish, H., S. M. H. Sarvari, and A. Behzadmehr. "Optimum design of a longitudinal fin array with convection and radiation heat transfer using a genetic algorithm." International journal of thermal sciences 49, no. 11 (2010): 2222-2229. https://doi.org/10.1016/j.ijthermalsci.2010.06.023
Nada, S. A., and M. A. Said. "Effects of fins geometries, arrangements, dimensions and numbers on natural convection heat transfer characteristics in finned-horizontal annulus." International Journal of Thermal Sciences 137 (2019): 121-137. https://doi.org/10.1016/j.ijthermalsci.2018.11.026
Bayrak, Fatih, Hakan F. Oztop, and Fatih Selimefendigil. "Effects of different fin parameters on temperature and efficiency for cooling of photovoltaic panels under natural convection." Solar Energy 188 (2019): 484-494. https://doi.org/10.1016/j.solener.2019.06.036
Adhikari, R. C., D. H. Wood, and M. Pahlevani. "Optimizing rectangular fins for natural convection cooling using CFD." Thermal Science and Engineering Progress 17 (2020): 100484. https://doi.org/10.1016/j.tsep.2020.100484
Altun, Aziz Hakan, and Orkun Ziylan. "Experimental investigation of the effects of horizontally oriented vertical sinusoidal wavy fins on heat transfer performance in case of natural convection." International Journal of Heat and Mass Transfer 139 (2019): 425-431. https://doi.org/10.1016/j.ijheatmasstransfer.2019.05.009
Adhikari, R. C., D. H. Wood, and M. Pahlevani. "An experimental and numerical study of forced convection heat transfer from rectangular fins at low Reynolds numbers." International Journal of Heat and Mass Transfer 163 (2020): 120418. https://doi.org/10.1016/j.ijheatmasstransfer.2020.120418
Shaeri, Mohammad Reza, and Richard Bonner. "Laminar forced convection heat transfer from laterally perforated-finned heat sinks." Applied Thermal Engineering 116 (2017): 406-418. https://doi.org/10.1016/j.applthermaleng.2016.12.103
Teh, A. L., Y. W. Phoo, W. M. Chin, E. H. Ooi, and J. J. Foo. "Forced convective heat transfer enhancement of 90° bend plate-fin heat sink with grid generated turbulence." Chemical Engineering Research and Design 156 (2020): 226-239. https://doi.org/10.1016/j.cherd.2019.12.004
Singh, Satyender. "Thermohydraulic performance of double pass solar thermal collector with inline, staggered and hybrid fin configurations." Journal of Energy Storage 27 (2020): 101080. https://doi.org/10.1016/j.est.2019.101080
Mousavi, Hamed, A. Ali Rabienataj Darzi, Mousa Farhadi, and Mohamad Omidi. "A novel heat sink design with interrupted, staggered and capped fins." International Journal of Thermal Sciences 127 (2018): 312-320. https://doi.org/10.1016/j.ijthermalsci.2018.02.003
Mokhtari, Mojtaba, M. Barzegar Gerdroodbary, Rezvan Yeganeh, and K. Fallah. "Numerical study of mixed convection heat transfer of various fin arrangements in a horizontal channel." Engineering science and technology, an international journal 20, no. 3 (2017): 1106-1114. https://doi.org/10.1016/j.jestch.2016.12.007
Irsyad, Muhammad, Muhammad Akmal, and M. D. Susila. "Heat Transfer Characteristics of Paraffin in Staggered Fins Heat Exchanger for the Cooling Process to Room Cooling Applications." In IOP Conference Series: Earth and Environmental Science, vol. 520, no. 1, p. 012009. IOP Publishing, 2020. https://doi.org/10.1088/1755-1315/520/1/012009
Hidayat, Y. P., and M. Irsyad. "Performance comparison of single and double pass PV/T solar collectors integrated with rectangular plate fin absorber." In IOP Conference Series: Materials Science and Engineering, vol. 1173, no. 1, p. 012023. IOP Publishing, 2021. https://doi.org/10.1088/1757-899X/1173/1/012023
Winardi, Warih, Joko Prasetyo, and Muhammad Irsyad. "Performance Analysis of PV/T-TEC collector for the tropical climate conditions of Indonesia." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 95, no. 2 (2022): 72-83. https://doi.org/10.37934/arfmts.95.2.7283
Prabowo, Angga Darma, Amrizal Amrizal, and Gusri Akhyar Ibrahim. "Geometry Optimization of PV/T-TEG Collector under Different Operating Conditions Using CFD Simulation and Taguchi Method." Engineering Journal 26, no. 8 (2022): 1-11. https://doi.org/10.4186/ej.2022.26.8.1
Özakin, Ahmet Numan, and Ferhat Kaya. "Effect on the exergy of the PVT system of fins added to an air-cooled channel: A study on temperature and air velocity with ANSYS Fluent." Solar energy 184 (2019): 561-569. https://doi.org/10.1016/j.solener.2019.03.100
Fan, Wenke, Georgios Kokogiannakis, Zhenjun Ma, and Paul Cooper. "Development of a dynamic model for a hybrid photovoltaic thermal collector–Solar air heater with fins." Renewable Energy 101 (2017): 816-834. https://doi.org/10.1016/j.renene.2016.09.039
Dogan, M., and M. Sivrioglu. "Experimental investigation of mixed convection heat transfer from longitudinal fins in a horizontal rectangular channel." International Journal of Heat and Mass Transfer 53, no. 9-10 (2010): 2149-2158. https://doi.org/10.1016/j.ijheatmasstransfer.2009.12.031
Prajapati, Yogesh K. "Influence of fin height on heat transfer and fluid flow characteristics of rectangular microchannel heat sink." International Journal of Heat and Mass Transfer 137 (2019): 1041-1052. https://doi.org/10.1016/j.ijheatmasstransfer.2019.04.012
Kim, Dong-Kwon, Jaehoon Jung, and Sung Jin Kim. "Thermal optimization of plate-fin heat sinks with variable fin thickness." International Journal of Heat and Mass Transfer 53, no. 25-26 (2010): 5988-5995. https://doi.org/10.1016/j.ijheatmasstransfer.2010.07.052
Kuvannarat, Thirapat, Chi-Chuan Wang, and Somchai Wongwises. "Effect of fin thickness on the air-side performance of wavy fin-and-tube heat exchangers under dehumidifying conditions." International journal of heat and mass transfer 49, no. 15-16 (2006): 2587-2596. https://doi.org/10.1016/j.ijheatmasstransfer.2006.01.020
Rosli, Mohd Afzanizam Mohd, Muhammad Zaid Nawam, Irfan Alias Farhan Latif, Safarudin Ghazali Herawan, Noriffah Md Noh, Siti Nur Dini Noordin Saleem, and Faridah Hussain. "The Effect of Variation in Mass Flow Rate and Solar Irradiance on Temperature Uniformity and Thermal Performance of Photovoltaic Thermal: A Simulated CFD Study." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 91, no. 2 (2022): 106-119. https://doi.org/10.37934/arfmts.91.2.106119
Ebrahim, Mila. "Performance Evaluation of a Photovoltaic/Thermal (PVT) Collector with Numerical Modelling."Master of Science Thesis Department of Energy Technology KTH (2021), TRITA-ITM-EX 2021:549
Fluent, A. N. S. Y. S. "ANSYS Fluent Theory Guide, Release 2020 R2." (2020).
Phu, Nguyen Minh, and Pham Ba Thao. "Thermohydraulic Performance of a Fin and Inclined Flat Tube Heat Exchanger: A Numerical Analysis." CFD Letters 13, no. 7 (2021): 1-12. https://doi.org/10.37934/cfdl.13.7.112
