The Effect of Single and Double Air Inlets on Swirling Flow in a Reactor of a Fluidized Bed Gasifier

Authors

  • Wasu Suksuwan Department of Mechanical Engineering, Faculty of Engineering, Prince of Songkla University, Hatyai, Songkhla 90112, Thailand
  • Makatar Wae-hayee Energy Technology Research Center, Faculty of Engineering, Prince of Songkla University, Hatyai, Songkhla 90112, Thailand
  • Maizirwan Mel Department of Biotechnology Engineering, Faculty of Engineering, International Islamic University, Malaysia

Keywords:

Flow characteristic , Swirl , fluidized bed gasifier, CFD

Abstract

In this work, the effect of single and double air inlets on swirling flow in a reactor of fluidized bed gasifier was studied numerically. The reactor diameter (D) was 20 cm, and the reactor length was 7.5D. The geometry of the reactor bottom was conical. In order to generate swirling flow in the reactor, the air inlet pipe with inner diameter of 46.8 mm was assembled tangentially to the bottom of the reactor. The comparison of the effect of single and double air inlets were studied based on the same mass flow rate. A 3-D numerical modelof the reactor was created using a commercial software of ANSYS Ver.15.0 (Fluent). The results showed that swirling flow at the bottom of the reactor for the case of double inlets was more uniform than that of single inlets. Therefore, double air inlets were applied to design and fabricate a swirling fluidized bed gasifier.

Downloads

Download data is not yet available.

Downloads

Published

2018-04-15

How to Cite

Wasu Suksuwan, Makatar Wae-hayee, & Maizirwan Mel. (2018). The Effect of Single and Double Air Inlets on Swirling Flow in a Reactor of a Fluidized Bed Gasifier. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 44(1), 157–166. Retrieved from https://semarakilmu.com.my/journals/index.php/fluid_mechanics_thermal_sciences/article/view/2695

Issue

Section

Articles

Most read articles by the same author(s)

1 2 > >>