Computational Fluid Dynamics of Two-Phase Flow Pressure Gradient of Air-Sodium Chloride and Glucose in Horizontal Capillary Channels

Authors

  • Sukamta Department of Mechanical Engineering, Faculty of Engineering, Universitas Muhammadiyah Yogyakarta, Indonesia
  • Rama Putrantyo Anwar Department of Mechanical Engineering, Faculty of Engineering, Universitas Muhammadiyah Yogyakarta, Indonesia
  • Sudarja Department of Mechanical Engineering, Faculty of Engineering, Universitas Muhammadiyah Yogyakarta, Indonesia
  • Sri Sundari Department of Medicine, Faculty of Medicine and Health Science, Universitas Muhammadiyah Yogyakarta, Indonesia
  • Mochamad Syamsiro Department of Mechanical Engineering, Faculty of Engineering, Universitas Janabadra, Indonesia

DOI:

https://doi.org/10.37934/cfdl.14.1.5265

Keywords:

Air-sodium chloride, computational fluid dynamics, glucose, pressure gradient, two-phase flow

Abstract

One of the problems in the two-phase flow is investigating the type of flow pattern that occurs in a mini channel without experimenting first. Computational Fluid Dynamics (CFD) is one way that can be used to predict pressure drop, flow pattern, void fraction, other parameters in fluid flow through a channel of a specific size. This research used the CFD simulations to predict the pressure gradient in a two-phase flow of air-sodium chloride 0.9% and glucose in a horizontal capillary tube with a diameter of 1.6 mm, and length of 70 mm. This research aims to obtain the simulation results of 2D and 3D pressure gradients to validate the experimental data. The simulation was carried out with a variation of the superficial gas velocity 0.1 - 8.3 m / s against the superficial velocity of the liquid constant 0.207 m / s. Simulations were carried out using the Volume of Fluid (VOF) model with the "ANSYS Fluent 2020 R1" software. In 2D and 3D simulations, the gradient values of pressure gradients tend to increase as JG increases. The pressure gradient fluctuates linearly at first, then exponentially from mid-to-end. The findings demonstrate that simulations may properly model physical processes like pattern creation and phase interactions. However, due to several physical elements considered in 3D simulation but missed in 2D simulation, the findings of the 2D and 3D simulations were dramatically different when looking at the pressure gradient values.

Downloads

Download data is not yet available.

Author Biographies

Sukamta, Department of Mechanical Engineering, Faculty of Engineering, Universitas Muhammadiyah Yogyakarta, Indonesia

sukamta@umy.ac.id

Rama Putrantyo Anwar, Department of Mechanical Engineering, Faculty of Engineering, Universitas Muhammadiyah Yogyakarta, Indonesia

rama.putrantyo@gmail.com

Sudarja, Department of Mechanical Engineering, Faculty of Engineering, Universitas Muhammadiyah Yogyakarta, Indonesia

sudarja@umy.ac.id

Sri Sundari, Department of Medicine, Faculty of Medicine and Health Science, Universitas Muhammadiyah Yogyakarta, Indonesia

sundari_purbo@umy.ac.id

Mochamad Syamsiro, Department of Mechanical Engineering, Faculty of Engineering, Universitas Janabadra, Indonesia

syamsiro@janabadra.ac.id

References

Faghri, Amir, and Yuwen Zhang. "Introduction to transport phenomena." Transport Phenomena in Multiphase Systems (2006): 1-106. https://doi.org/10.1016/B978-0-12-370610-2.50006-4

Cavallini, A., D. Del Col, L. Doretti, M. Matkovic, L. Rossetto, and C. Zilio. "Two-phase frictional pressure gradient of R236ea, R134a and R410A inside multi-port mini-channels." Experimental Thermal and Fluid Science 29, no. 7 (2005): 861-870. https://doi.org/10.1016/j.expthermflusci.2005.03.012

Ghorai, Subhashini, and K. D. P. Nigam. "CFD modeling of flow profiles and interfacial phenomena in two-phase flow in pipes." Chemical Engineering and Processing: Process Intensification 45, no. 1 (2006): 55-65. https://doi.org/10.1016/j.cep.2005.05.006

Ekambara, K., Mahesh T. Dhotre, and Jyeshtharaj B. Joshi. "CFD simulations of bubble column reactors: 1D, 2D and 3D approach." Chemical Engineering Science 60, no. 23 (2005): 6733-6746. https://doi.org/10.1016/j.ces.2005.05.047

Lahey Jr, Richard T., and Donald A. Drew. "The analysis of two-phase flow and heat transfer using a multidimensional, four field, two-fluid model." Nuclear Engineering and Design 204, no. 1-3 (2001): 29-44. https://doi.org/10.1016/S0029-5493(00)00337-X

Moraveji, Mostafa Keshavarz, and Reza Mohammadi Ardehali. "CFD modeling (comparing single and two-phase approaches) on thermal performance of Al2O3/water nanofluid in mini-channel heat sink." International Communications in Heat and Mass Transfer 44 (2013): 157-164. https://doi.org/10.1016/j.icheatmasstransfer.2013.02.012

Kandlikar, Satish G., and William J. Grande. "Evolution of microchannel flow passages--thermohydraulic performance and fabrication technology." Heat Transfer Engineering 24, no. 1 (2003): 3-17. https://doi.org/10.1080/01457630304040

Ajayi, N. O., L. Lazarus, E. A. Vanker, and K. S. Satyapal. "Anatomic Parameters of the Left Coronary Artery: an Angiographic Study in a South African Population." International Journal of Morphology 31, no. 4 (2013): 1393-1398. https://doi.org/10.4067/S0717-95022013000400039

Sharan, Maithili, and Aleksander S. Popel. "A two‐phase model for flow of blood in narrow tubes with increased effective viscosity near the wall." Biorheology 38, no. 5, 6 (2001): 415-428.

Sukamta, Sukamta. "Computational fluid dynamics (CFD) and experimental study of two-phase flow patterns gas-liquid with low viscosity in a horizontal capillary pipe." CFD Letters 11, no. 8 (2019): 16-23.

Khan, Noor Saeed, Poom Kumam, and Phatiphat Thounthong. "Computational approach to dynamic systems through similarity measure and homotopy analysis method for renewable energy." Crystals 10, no. 12 (2020): 1086. https://doi.org/10.3390/cryst10121086

Khan, Noor Saeed, Auwalu Hamisu Usman, Arif Sohail, Abid Hussanan, Qayyum Shah, Naeem Ullah, Poom Kumam, and Phatiphat Thounthong. "A Framework for the Magnetic Dipole Effect on the Thixotropic Nanofluid Flow Past a Continuous Curved Stretched Surface." Crystals 11, no. 6 (2021): 645. https://doi.org/10.3390/cryst11060645

Zuhra, Samina, Noor Saeed Khan, Muhammad Altaf Khan, Saeed Islam, Waris Khan, and Ebenezer Bonyah. "Flow and heat transfer in water based liquid film fluids dispensed with graphene nanoparticles." Results in Physics 8 (2018): 1143-1157. https://doi.org/10.1016/j.rinp.2018.01.032

Bahnasy, Amal, and A. M. Abdel-Wahab. "Mathematical Model Represents the Effect of Flexible Endoscopy on Suspension Fluid Flow." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 89, no. 1 (2022): 42-61. https://doi.org/10.37934/arfmts.89.1.4261

Thirupathi, Gurrala, Kamatam Govardhan, and Ganji Narender. "Radiative Magnetohydrodynamics Casson Nanofluid Flow and Heat and Mass Transfer past on Nonlinear Stretching Surface." Journal of Advanced Research in Numerical Heat Transfer 6, no. 1 (2021): 1-21.

Mosdorf, R. "Modelling of two-phase flow in a minichannel using level-set method." In Journal of Physics: Conference Series, vol. 530, no. 1. IOP Publishing, 2014. https://doi.org/10.1088/1742-6596/530/1/012049

Alfarawi, Suliman, Raya Al-Dadah, and Saad Mahmoud. "Transient investigation of mini-channel regenerative heat exchangers." Applied Thermal Engineering 125 (2017): 346-358. https://doi.org/10.1016/j.applthermaleng.2017.07.038

Ghiasi, Pedram, Amar Salehi, Seyed Salar Hoseini, Gholamhassan Najafi, Rizalman Mamat, Balkhaya Balkhaya, and Fitri Khoerunnisa. "Investigation of the Effect of Flow Rate on Fluid Heat Transfer in Counter-Flow Helical Heat Exchanger Using CFD Method." CFD Letters 12, no. 3 (2020): 98-111. https://doi.org/10.37934/cfdl.12.3.98111

Sedeh, Shahab Naghdi, and Davood Toghraie. "The thermal performance of five different viscosity models in the kidney blood vessel with multi-phase mixture of non-Newtonian fluid models using computational fluid dynamics." Archive of Applied Mechanics 91, no. 5 (2021): 1887-1895. https://doi.org/10.1007/s00419-021-01911-7

Ciuti, Gastone, Leonardo Ricotti, Arianna Menciassi, and Paolo Dario. "MEMS sensor technologies for human centred applications in healthcare, physical activities, safety and environmental sensing: A review on research activities in Italy." Sensors 15, no. 3 (2015): 6441-6468. https://doi.org/10.3390/s150306441

Verweij, B. H., G. J. Amelink, and Jan Paul Muizelaar. "Current concepts of cerebral oxygen transport and energy metabolism after severe traumatic brain injury." Progress in Brain Research 161 (2007): 111-124. https://doi.org/10.1016/S0079-6123(06)61008-X

Paulson, Olaf B., Steen G. Hasselbalch, Egill Rostrup, Gitte Moos Knudsen, and Dale Pelligrino. "Cerebral blood flow response to functional activation." Journal of Cerebral Blood Flow & Metabolism 30, no. 1 (2010): 2-14. https://doi.org/10.1038/jcbfm.2009.188

Kainz, Wolfgang, Esra Neufeld, Wesley E. Bolch, Christian G. Graff, Chan Hyeong Kim, Niels Kuster, Bryn Lloyd et al. "Advances in computational human phantoms and their applications in biomedical engineering-a topical review." IEEE Transactions on Radiation and Plasma Medical Sciences 3, no. 1 (2018): 1-23. https://doi.org/10.1109/TRPMS.2018.2883437

Pang, Zhibo, Geng Yang, Ridha Khedri, and Yuan-Ting Zhang. "Introduction to the special section: convergence of automation technology, biomedical engineering, and health informatics toward the healthcare 4.0." IEEE Reviews in Biomedical Engineering 11 (2018): 249-259. https://doi.org/10.1109/RBME.2018.2848518

Downloads

Published

2022-01-11

Issue

Section

Articles