Influence of Dimples on the Aerodynamics of Blended Wing Body Airframe: A Computational Study

Authors

  • Haris Ali Department of Mechanical and Manufacturing Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 Bangi, Selangor, Malaysia
  • Mohammad Rasidi Rasani Department of Mechanical and Manufacturing Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 Bangi, Selangor, Malaysia
  • Zambri Harun Department of Mechanical and Manufacturing Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 Bangi, Selangor, Malaysia

DOI:

https://doi.org/10.37934/cfdl.17.6.4556

Keywords:

Aerodynamics, CFD, turbulence, dimples, lift, drag

Abstract

Blended-Wing-Body (BWB) aircraft designs have attracted considerable attention due to their potential for enhancing aerodynamic efficiency and fuel economy. This study investigates the integration of dimples on BWB airframes to further improve their aerodynamic performance. Computational Fluid Dynamics (CFD) simulations were used to characterize turbulent airflow and estimate the associated aerodynamic forces. The k-ω Shear-Stress Transport (SST) turbulence model was employed to solve the underlying equations. The objective is to investigate the impact of various dimple locations on the suction side of the BWB wing. The simulations were performed at the free stream velocity of 50m/s over the angle of attack ranging from -2° to 6°. The evaluation involved analysing the drag coefficient (CD), lift coefficient (CL) and lift-to-drag (L/D) ratio. The results suggest that in optimal conditions, a BWB featuring a dimpled surface could achieve a reduction in CD of up to 3.04% compared to an unmodified surface, while maintaining lift performance. The results illustrate the feasibility of integrating dimples as a passive flow control technique to enhance BWB aerodynamic performance

Downloads

Author Biographies

Haris Ali, Department of Mechanical and Manufacturing Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 Bangi, Selangor, Malaysia

harris.alii256@gmail.com

Mohammad Rasidi Rasani, Department of Mechanical and Manufacturing Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 Bangi, Selangor, Malaysia

rasidi@ukm.edu.my

Zambri Harun, Department of Mechanical and Manufacturing Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 Bangi, Selangor, Malaysia

zambri@ukm.edu.my

References

Liu, Zhongyuan, Lie Luo and Binqian Zhang. "An aerodynamic design method to improve the high-speed performance of a low-aspect-ratio tailless aircraft." Applied Sciences 11, no. 4 (2021): 1555. https://doi.org/10.3390/app11041555 DOI: https://doi.org/10.3390/app11041555

Liebeck, Robert H. "Design of the blended wing body subsonic transport." Journal of aircraft 41, no. 1 (2004): 10-25. https://doi.org/10.2514/1.9084 DOI: https://doi.org/10.2514/1.9084

Li, Yonghong and Ning Qin. "Influence of spanwise load distribution on blended-wing–body performance at transonic speed." Journal of Aircraft 57, no. 3 (2020): 408-417. https://doi.org/10.2514/1.C035696 DOI: https://doi.org/10.2514/1.C035696

Muta’ali, Atikah Basyirah Abdul, Rizal Effendy Mohd Nasir, Wirachman Wisnoe and Wahyu Kuntjoro. "Aerodynamic performance of a tail-less blended wing-body small transport aircraft." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 66, no. 1 (2020): 135-150.

Suewatanakul, Siwat, Alessandro Porcarelli, Adam Olsson, Henrik Grimler, Ariel Chiche, Raffaello Mariani and Göran Lindbergh. "Conceptual design of a hybrid hydrogen fuel cell/battery blended-wing-body unmanned aerial vehicle—an overview." Aerospace 9, no. 5 (2022): 275. https://doi.org/10.3390/aerospace9050275 DOI: https://doi.org/10.3390/aerospace9050275

Liersch, Carsten M., Russel M. Cummings and Andreas Schütte. "Multi-Disciplinary Design and Performance Assessment of Effective, Agile NATO Air Vehicles." NATO STO Technical Report RDP, STO-TR-AVT-251 on" Multi-Disciplinary Design and Performance Assessment of Effective, Agile NATO Air Vehicles" (2021). https://doi.org/10.1016/j.ast.2020.105764 DOI: https://doi.org/10.1016/j.ast.2020.105764

Mitridis, D., N. Mathioudakis, P. Panagiotou and K. Yakinthos. "Development of a Cargo Airdrop Modeling Method for a Tactical Blended-Wing-Body UAV." In IOP Conference Series: Materials Science and Engineering, vol. 1024, no. 1, p. 012044. IOP Publishing, 2021. https://doi.org/10.1088/1757-899X/1024/1/012044 DOI: https://doi.org/10.1088/1757-899X/1024/1/012044

Panagiotou, P. and K. Yakinthos. "Aerodynamic efficiency and performance enhancement of fixed-wing UAVs." Aerospace Science and Technology 99 (2020): 105575. https://doi.org/10.1016/j.ast.2019.105575 DOI: https://doi.org/10.1016/j.ast.2019.105575

Romli, Fairuz Izzuddin, Muhammad Aiman Mohammad Sabri and Rizal Effendy Mohd Nasir. "Optimization of a Blended-Wing-Body Unmanned Aerial Vehicle Design for Maximum Aerodynamic Lift-to-Drag Ratio." CFD Letters 15, no. 3 (2023): 12-21. https://doi.org/10.37934/cfdl.15.3.1221 DOI: https://doi.org/10.37934/cfdl.15.3.1221

Abbas, Adel, Gabriel Bugeda, Esteban Ferrer, Song Fu, Jacques Periaux, Jordi Pons-Prats, Eusebio Valero and Yao Zheng. "Drag reduction via turbulent boundary layer flow control." Science China Technological Sciences 60 (2017): 1281-1290. https://doi.org/10.1007/s11431-016-9013-6 DOI: https://doi.org/10.1007/s11431-016-9013-6

Gattere, Federica, Alessandro Chiarini and Maurizio Quadrio. "Dimples for skin-friction drag reduction: Status and perspectives." Fluids 7, no. 7 (2022): 240. https://doi.org/10.3390/fluids7070240 DOI: https://doi.org/10.3390/fluids7070240

Merryisha, Samuel and Parvathy Rajendran. "Review of winglets on tip vortex, drag and airfoil geometry." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 63, no. 2 (2019): 218-237.

Harun, Zambri, Ashraf Amer Abbas, Bagus Nugroho, Leon Chan and Sohif Mat. "Surface roughness effects studies in transportation industries." Jurnal Kejuruteraan SI 1, no. 7 (2018): 87-90. https://doi.org/10.17576/jkukm-2018-si1(7)-11 DOI: https://doi.org/10.17576/jkukm-2018-si1(7)-11

Cacciatori, Lorenzo, Carlo Brignoli, Benedetto Mele, Federica Gattere, Celeste Monti and Maurizio Quadrio. "Drag reduction by riblets on a commercial UAV." Applied Sciences 12, no. 10 (2022): 5070. https://doi.org/10.3390/app12105070 DOI: https://doi.org/10.3390/app12105070

Koga, Seigo, Hiroyuki Abe, Yoshimi Iijima, Mitsuru Kurita, Dong-Youn Kwak, Akira Nishizawa, Hidemi Takahashi and Hidetoshi Iijima. "Flight Test for Paint-Riblet." In AIAA Scitech 2020 Forum. American Institute of Aeronautics and Astronautics (AIAA), 2020.

Leontiev, A. I., N. A. Kiselev, Yu A. Vinogradov, M. M. Strongin, A. G. Zditovets and S. A. Burtsev. "Experimental investigation of heat transfer and drag on surfaces coated with dimples of different shape." International Journal of Thermal Sciences 118 (2017): 152-167. https://doi.org/10.1016/j.ijthermalsci.2017.04.027 DOI: https://doi.org/10.1016/j.ijthermalsci.2017.04.027

Choi, Jin, Woo-Pyung Jeon and Haecheon Choi. "Mechanism of drag reduction by dimples on a sphere." Physics of Fluids 18, no. 4 (2006). https://doi.org/10.1063/1.2191848 DOI: https://doi.org/10.1063/1.2191848

Allarton, Richard, Jun Yao, Tyler Clifford, Benjamin Hitchborn, Liam J. Parker and Joshua Shaw. "Surface flow modification of aerofoils for automotive racing car applications." International Journal of Modern Physics B 34, no. 14n16 (2020): 2040096. https://doi.org/10.1142/S0217979220400962 DOI: https://doi.org/10.1142/S0217979220400962

Asai, Takeshi, Shinichiro Ito, Kazuya Seo and Akihiro Hitotsubashi. "Fundamental aerodynamics of a new volleyball." Sports Technology 3, no. 4 (2010): 235-239. https://doi.org/10.1080/19346182.2012.663528 DOI: https://doi.org/10.1080/19346182.2012.663528

Joseph, D. Raja, P. Booma Devi and M. Gopalsamy. "Investigation on effect of square dimples on NACA0012 airfoil with various Reynolds numbers." International Journal of Ambient Energy 42, no. 4 (2021): 397-402. https://doi.org/10.1080/01430750.2018.1531267 DOI: https://doi.org/10.1080/01430750.2018.1531267

Tay, Jonathan and Tee Tai Lim. "Drag reduction with teardrop-shaped dimples." In 2018 Flow Control Conference, p. 3528. 2018. https://doi.org/10.2514/6.2018-3528 DOI: https://doi.org/10.2514/6.2018-3528

Azlan, Fahmi, Ming Kwang Tan, Boon Thong Tan and M-Z. Ismadi. "Passive flow-field control using dimples for performance enhancement of horizontal axis wind turbine." Energy 271 (2023): 127090. https://doi.org/10.1016/j.energy.2023.127090 DOI: https://doi.org/10.1016/j.energy.2023.127090

Zhang, G. Q., J. Schlüter and Xiaojian Hu. "Parametric investigation of drag reduction for marine vessels using air-filled dimpled surfaces." Ships and Offshore Structures 13, no. 3 (2018): 244-255. https://doi.org/10.1080/17445302.2017.1357961 DOI: https://doi.org/10.1080/17445302.2017.1357961

Palanivendhan, M., J. Chandradass, C. Saravanan, Jennifer Philip and R. Sharan. "Reduction in aerodynamic drag acting on a commercial vehicle by using a dimpled surface." Materials Today: Proceedings 45 (2021): 7072-7078. https://doi.org/10.1016/j.matpr.2021.01.884 DOI: https://doi.org/10.1016/j.matpr.2021.01.884

Ali, Haris, Mohammad Rasidi Rasani, Zambri Harun and Muhammad Ashhad Shahid. "Passive flow-field control using dimples for improved aerodynamic flow over a wing." Scientific Reports 14, no. 1 (2024): 12918. https://doi.org/10.1038/s41598-024-63638-z DOI: https://doi.org/10.1038/s41598-024-63638-z

Shafique M. “Aerodynamic Design and Optimization of a Low Observable Aircraft” [master's thesis].” Islamabad: Institute of Space Technology, Department of Aeronautics and Astronautics, (2022).

Eng, Yong, C. M. J. Tay and B. C. Khoo. "Drag and heat transfer in turbulent channel flow over shallow circular dimples: The shift of the deepest point of dimples." International Journal of Thermal Sciences 185 (2023): 108049. https://doi.org/10.1016/j.ijthermalsci.2022.108049 DOI: https://doi.org/10.1016/j.ijthermalsci.2022.108049

Anderson, John David and Mary L. Bowden. Introduction to flight. Vol. 582. New York, NY, USA: McGraw-Hill Higher Education, 2005.

Menter, Florian R. "Two-equation eddy-viscosity turbulence models for engineering applications." AIAA journal 32, no. 8 (1994): 1598-1605. https://doi.org/10.2514/3.12149 DOI: https://doi.org/10.2514/3.12149

Mor-Yossef, Yair. "Improved convergence characteristics of two-equation turbulence models on unstructured grids." Computers & Fluids 230 (2021): 105127. https://doi.org/10.1016/j.compfluid.2021.105127 DOI: https://doi.org/10.1016/j.compfluid.2021.105127

Downloads

Published

2024-12-31

Issue

Section

Articles
Crossref
0
Scopus
0

Similar Articles

<< < 2 3 4 5 6 7 8 9 10 11 > >> 

You may also start an advanced similarity search for this article.