CFD Simulation Analysis of Sub-Component in Municipal Solid Waste Gasification Using Plasma Downdraft Technique

Authors

  • Nelvin Kaw Chee Qing Department of Mechanical Engineering Technology, Faculty of Engineering Technology, Universiti Tun Hussein Onn Malaysia, Pagoh Johor, 84600 Malaysia
  • Nor Afzanizam Samiran Department of Mechanical Engineering Technology, Faculty of Engineering Technology, Universiti Tun Hussein Onn Malaysia, Pagoh Johor, 84600 Malaysia
  • Razlin Abd Rashid Department of Mechanical Engineering Technology, Faculty of Engineering Technology, Universiti Tun Hussein Onn Malaysia, Pagoh Johor, 84600 Malaysia

DOI:

https://doi.org/10.37934/cfdl.14.8.6370

Keywords:

Gasification, Plasma, Downdraft, Food waste, Paper, Yard waste, Syngas composition

Abstract

Plasma gasification technology is one of the potential methods to decompose dangerous wastes and turn them into non-leachable slag due to it greater energy efficiency and bottom ash prevention concerns. However, a fundamental study of CFD simulation on the reaction flow characteristic using the operational of plasma gasification process was scarce. The present study aims to investigate the gasification characteristic of municipal solid waste (MSW) component including food waste, paper, and yard waste to produce synthesis gas using a 3-dimensional CFD simulation method in the downdraft plasma gasifier. The reaction model of non-premixed combustion, Euler-Lagrangian approach and K- ε turbulence model was used as a setup parameter. Plasma being consider as hot gas with 1173K, coal as 293K and air inlet on 673K. Flowrate of feedstocks, plasma gas flow and air flowrate are set to 0.029 kg/s, 0.0438kg/s, and 0.0029kg/s respectively. Based on the result and comparison between those feedstocks, food waste typically produced higher CH4, CO, and CO2 than paper and yard. Yard wastes yield the highest H2 content which consist of 0.544 mole fraction, with 539.24% higher than food waste and 79.76% higher than paper. The result showed that gasification of different component from MSW produced different characteristic of syngas based on the properties of the feedstock.

Downloads

Download data is not yet available.

Author Biographies

Nor Afzanizam Samiran, Department of Mechanical Engineering Technology, Faculty of Engineering Technology, Universiti Tun Hussein Onn Malaysia, Pagoh Johor, 84600 Malaysia

afzanizam@uthm.edu.my

Razlin Abd Rashid, Department of Mechanical Engineering Technology, Faculty of Engineering Technology, Universiti Tun Hussein Onn Malaysia, Pagoh Johor, 84600 Malaysia

razlin@uthm.edu.my

References

Samad, Noor Asma Fazli Abdul, Nur Ashikin Jamin, and Suriyati Saleh. "Torrefaction of municipal solid waste in Malaysia." Energy Procedia 138 (2017): 313-318. https://doi.org/10.1016/j.egypro.2017.10.106

Bashir, M. J. K., C. A. Ng, S. Sethupathi, and J. W. Lim. "Assessment of the environmental, technical and economic issues associated with energy recovery from municipal solid waste in Malaysia." In IOP Conference Series: Earth and Environmental Science, vol. 268, no. 1, p. 012044. IOP Publishing, 2019. https://doi.org/10.1088/1755-1315/268/1/012044

Sadhukhan, Jhuma, Elias Martinez-Hernandez, Richard J. Murphy, Denny KS Ng, Mimi H. Hassim, Kok Siew Ng, Wan Yoke Kin, Ida Fahani Md Jaye, Melissa Y. Leung Pah Hang, and Viknesh Andiappan. "Role of bioenergy, biorefinery and bioeconomy in sustainable development: Strategic pathways for Malaysia." Renewable and Sustainable Energy Reviews 81 (2018): 1966-1987. https://doi.org/10.1016/j.rser.2017.06.007

Yong, Zi Jun, Mohammed JK Bashir, Choon Aun Ng, Sumathi Sethupathi, Jun Wei Lim, and Pau Loke Show. "Sustainable waste-to-energy development in Malaysia: Appraisal of environmental, financial, and public issues related with energy recovery from municipal solid waste." Processes 7, no. 10 (2019): 676. https://doi.org/10.3390/pr7100676

Kamaruzaman, Nursyuhada', Zahrul Faizi Mohd Shadzalli, and Norhuda Abdul Manaf. "Waste-Energy-Climate Nexus Perspective Towards Circular Economy: A Mini-Review." Journal of Advanced Research in Applied Sciences and Engineering Technology 26, no. 1 (2022): 31-41. https://doi.org/10.37934/araset.26.1.3141

Ismail, Tamer M., Ana Ramos, M. Abd El-Salam, Eliseu Monteiro, and Abel Rouboa. "Plasma fixed bed gasification using an Eulerian model." International Journal of Hydrogen Energy 44, no. 54 (2019): 28668-28684. https://doi.org/10.1016/j.ijhydene.2019.08.035

Munir, M. T., I. Mardon, S. Al-Zuhair, A. Shawabkeh, and N. U. Saqib. "Plasma gasification of municipal solid waste for waste-to-value processing." Renewable and Sustainable Energy Reviews 116 (2019): 109461. https://doi.org/10.1016/j.rser.2019.109461

Tan, Nurfarah Diana Mohd Ridzuan, Fudhail Abdul Munir, Musthafah Mohd Tahir, Herman Saputro, and Masato Mikami. "Preliminary Investigation of Using DBD Plasma for Application in Micro Combustors." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 82, no. 1 (2021): 105-112. https://doi.org/10.37934/arfmts.82.1.105112

Erdogan, Altug Alp, and Mustafa Zeki Yilmazoglu. "Plasma gasification of the medical waste." International Journal of Hydrogen Energy 46, no. 57 (2021): 29108-29125. https://doi.org/10.1016/j.ijhydene.2020.12.069

Ibrahimoglu, Beycan, and M. Zeki Yilmazoglu. "Numerical modeling of a downdraft plasma coal gasifier with plasma reactions." International Journal of Hydrogen Energy 45, no. 5 (2020): 3532-3548. https://doi.org/10.1016/j.ijhydene.2018.12.198

Mazzoni, Luca, Manar Almazrouei, Chaouki Ghenai, and Isam Janajreh. "A comparison of energy recovery from MSW through plasma gasification and entrained flow gasification." Energy Procedia 142 (2017): 3480-3485. https://doi.org/10.1016/j.egypro.2017.12.233

Shehzad, Areeb, Mohammed JK Bashir, and Sumathi Sethupathi. "System analysis for synthesis gas (syngas) production in Pakistan from municipal solid waste gasification using a circulating fluidized bed gasifier." Renewable and Sustainable Energy Reviews 60 (2016): 1302-1311. https://doi.org/10.1016/j.rser.2016.03.042

Fortunato, Bernardo, Gianluigi Brunetti, Sergio Mario Camporeale, Marco Torresi, and Francesco Fornarelli. "Thermodynamic model of a downdraft gasifier." Energy Conversion and Management 140 (2017): 281-294. https://doi.org/10.1016/j.enconman.2017.02.061

Seo, Yong-Chil, Md Tanvir Alam, and Won-Seok Yang. "Gasification of municipal solid waste." Gasification for Low-Grade Feedstock (2018): 115-141. https://doi.org/10.5772/intechopen.73685

Ma, Meng, Jiaofei Wang, Yonghui Bai, Peng Lv, Xudong Song, Weiguang Su, Lu Ding, Juntao Wei, and Guangsuo Yu. "Deactivation mechanism of coal char gasification reactivity induced by cow manure biomass volatile-coal char interactions." Fuel 301 (2021): 121064. https://doi.org/10.1016/j.fuel.2021.121064

Ibrahimoglu, Beycan, Ahmet Cucen, and M. Zeki Yilmazoglu. "Numerical modeling of a downdraft plasma gasification reactor." International Journal of Hydrogen Energy 42, no. 4 (2017): 2583-2591. https://doi.org/10.1016/j.ijhydene.2016.06.224

Hakim, Kbab, Hamitouche Toufik, and Y. Mouloudj. "Study and Simulation of the Thrust Vectoring in Supersonic Nozzles." Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 93, no. 1 (2022): 13-24. https://doi.org/10.37934/arfmts.93.1.1324

Musa, Solihin, Nor Azwadi Che Sidik, Siti Nurul Akmal Yusof, and Erdiwansyah Erdiwansyah. "Analysis of Internal Flow in Bag Filter by Different Inlet Angle." Journal of Advanced Research in Numerical Heat Transfer 3, no. 1 (2020): 12-24.

Evaristo, Rafael B. W., Ricardo Ferreira, Juliana Petrocchi Rodrigues, Juliana Sabino Rodrigues, Grace F. Ghesti, Edgar A. Silveira, and M. Costa. "Multiparameter-analysis of CO2/Steam-enhanced gasification and pyrolysis for syngas and biochar production from low-cost feedstock." Energy Conversion and Management: X 12 (2021): 100138. https://doi.org/10.1016/j.ecmx.2021.100138

Downloads

Published

2022-08-20

How to Cite

Nelvin Kaw Chee Qing, Nor Afzanizam Samiran, & Razlin Abd Rashid. (2022). CFD Simulation Analysis of Sub-Component in Municipal Solid Waste Gasification Using Plasma Downdraft Technique. CFD Letters, 14(8), 63–70. https://doi.org/10.37934/cfdl.14.8.6370

Issue

Section

Articles

Most read articles by the same author(s)